- Home
- FACE PRO
- Audio solutions
- Immersive technology
- Processors
- TiMax TTd4 Sensor
TiMax TTd4 Sensor
Sensor Connection
Sensors are provided with an Ethercon Rj45 connector which carries PoE power, network data and a timing signals. Sensors are synchronised with each other to within a fraction of a nanosecond using signals sent between them on spare lines of the Ethernet cables, network data and timing signals are combined in the passive Timing Hub.
Sensors can run without any synchronisation in an AoA-only positioning mode.
Sensor LEDsThe top tri-colour LED indicates boot status and will repeatedly flash afour colour sequence as an error code if it fails to boot. Refer to theBoot Process document for details.
The 3 LEDs at the bottom are Network Status LEDs
Top LED (Red). If this LED is on, the Ethernet link has been established.
Middle LED (Green) - on indicates activity on the Ethernet link.
Bottom LED (Yellow) - shows the speed of the Ethernet link.
If the LED is off, the speed is 10 Mbps
If the LED is on, the speed is 100 Mbps
Power Supply - Power-over-ethernet IEEE 802.3af compatible
Temperature Range - -40 to 149 (-40 to 65”)
Humidity - 0 to 95% non-condensing
Protection levels IP30
Case - Black UV Stabilized Ip30
Radio Frequency - Ultra-wideband channel 6 - 7GHz
Connections - 1 x Ethercon
Certifications - US: FCC Part 15 FCC ID SEASENSOR30, Canada: RSS-GEN, RSS-210, RSS-220; IC: 8673A-SENSOR30, EU: CE
Sensor Connection
Sensors are provided with an Ethercon Rj45 connector which carries PoE power, network data and a timing signals. Sensors are synchronised with each other to within a fraction of a nanosecond using signals sent between them on spare lines of the Ethernet cables, network data and timing signals are combined in the passive Timing Hub.
Sensors can run without any synchronisation in an AoA-only positioning mode.
Sensor LEDsThe top tri-colour LED indicates boot status and will repeatedly flash afour colour sequence as an error code if it fails to boot. Refer to theBoot Process document for details.
The 3 LEDs at the bottom are Network Status LEDs
Top LED (Red). If this LED is on, the Ethernet link has been established.
Middle LED (Green) - on indicates activity on the Ethernet link.
Bottom LED (Yellow) - shows the speed of the Ethernet link.
If the LED is off, the speed is 10 Mbps
If the LED is on, the speed is 100 Mbps
Power Supply - Power-over-ethernet IEEE 802.3af compatible
Temperature Range - -40 to 149 (-40 to 65”)
Humidity - 0 to 95% non-condensing
Protection levels IP30
Case - Black UV Stabilized Ip30
Radio Frequency - Ultra-wideband channel 6 - 7GHz
Connections - 1 x Ethercon
Certifications - US: FCC Part 15 FCC ID SEASENSOR30, Canada: RSS-GEN, RSS-210, RSS-220; IC: 8673A-SENSOR30, EU: CE
Specifications
| Accessory type | Sensor |
| Brand | TiMax |